Solar Boost 2000E Maximum Power Point Tracking Photovotaic Charge Controller 

Patented Maximum Power Point Tracking (MPPT) technology allows Solar Boost 2000E to increase charge current up to 30% or more compared to conventional charge controllers. Don’t waste money by throwing PV power away! Get the power you paid for with a Solar Boost charge controller. The Solar Boost 2000E provides a precision Multi-stage Pulse Width Modulation (PWM) charge control system to ensure the battery is properly and fully charged, resulting in enhanced battery performance with less battery maintenance. An equalize function is also included to periodically condition liquid electrolyte lead-acid batteries. A built in LCD digital display monitors solar charge performance. The display shows battery voltage, solar panel current and output charge current. You can actually see current boost working by noting the difference between solar panel current and output charge current. A charge status LED indicates the present charge mode, and shows when the battery has become fully charged.

Features:

• Patented MPPT Technology Increases Charge Current up to 30% Or More!
• 12 Volt / 25 Amp Rating Supports Medium Sized Solar Module Arrays
• Multi-stage Stage PWM Charge Control Improves Battery Performance & Life
• Electronic Current Limit Prevents Overload Or Nuisance Fuse Blow
• LCD Digital Display Monitors PV Charge Performance
• Durable Powder Coat Finish & Conformal Coated Electronics Resist Corrosion
• Available Temperature Compensation Further Improves Battery Performance & Life
• Fully Protected Against Excess Current, Temperature, Transient Voltage & Polarity
• Full 36 Month Limited Warranty, Optional Extended Coverage Available

Specifications:

Output Current Rating

25 Amp Maximum (Output current limit 25.0± 0.5A)

Nominal System Voltage

12 VDC

PV Open Circuit Voltage

30 VDC Maximum

Standby Power Consumption

17mA Typical

Charge On Power Consumption

70mA Typical

Charge Algorithm

Fully automatic two stage charge, Bulk & Constant Voltage. A third manually actuated. Equalize charge function is included to periodically condition lead-acid batteries.

Charge Voltage Setpoint Range

13–16VDC (14.0VDC initial factory setting)

Equalization Voltage

Charge voltage setting +1.2VDC

Temperature Compensation

Optional temperature sensor adjusts charge voltage setpoint based on measured battery temperature. Field selectable slope, –5.0mV/°C/cell (lead-acid), or –2.0mV/°C/cell (NiCd)

Power Conversion Efficiency

Open frame construction with conformal coated electronics visible from rear. Designed tomount into a rectangular surface cutout. Optional conduit ready surface mount box available.

Panel Dimensions

95% @ 15 Amp Output

Construction

4 5/8”H x 6 3/8”W x 1 7/8”D (11.75cm x 16.19cm x 4.76cm)

Front Panel Displays

LCD digital display shows PV module input current, output charge current and battery

Digital Display Range/Accuracy

voltage. Charge status LED shows present charge mode and battery state of charge.

Specified Temperature Range

0 to +40°C (Extended range –40 to +50°C, will operate but may not meet spec.)