|
For current pricing, call us toll-free 1-877-964-4188.
|
|
Specfications
|
The
MATE
|
|
Interface
Display
|
4
line 80 character backlit LCD - Alphanumeric with graphic
symbols
|
|
Control
Keypad
|
6
backlit silicone membrane keys- dedicated inverter and AC
input keys
|
|
Status
Indicators
|
Two
LED Status Indicators : Green = Inverter Yellow = AC Input
|
|
Communication
Protocol
|
Proprietary
OutBack Multi-drop using an OutBack HUB
|
|
Interconnection
Cabling
|
Standard
CAT 5 network cable with RJ45 modular jack - 50 ft included
|
|
PC
Computer Interface
|
RS232
opto-isolated DB9 jack 9600 baud serial communication
|
|
Microprocessor
|
16
MHz low power consumption version
|
|
Setpoint
and Data Memory
|
32K
non-volatile flash RAM
|
|
Clock
/ Calendar
|
On-board
real time clock with battery backup
|
|
Audible
Indicator
|
2
KHz Transducer
|
|
Environmental
Rating
|
Indoor
Type 1 Optional outdoor Type 3R transparent lockable cover
|
|
Dimensions
|
5.75”
W x 4.25” H x 2” D 14.6 cm x 10.8 cm x 5.08 cm
|
|
Shipping
Weight
|
1
lb - 454 g
|
|
Warranty
|
Two
years parts and labor Optional Extended Warranty
|
Home
| Turnkey Systems
The
OutBack MATE is a complete system controller and display for
both the OutBack FX2000 inverter/charger and MX60 MPPT PV charge
controller. It provides a display of the operation as well as
allows control and adjustment of the setpoints. The OutBack
Mate also coordinates the operation of the entire system to
maximize performance and to prevent multiple products from conflicting.
A single OutBack MATE is able to connect to multiple FX2000
inverter/charges, MX60 MPPT PV charge controllers and any other
OutBack power conversion
and control products offered in the future. A maximum of ten
OutBack products will be able to be connected to a single MATE
via CAT 5 / ethernet type cabling with 8 wire RJ45 modular connectors
and the OutBack HUB communication manager. The OutBack MATE
includes a 4 line backlit LCD display with 80 alphanumeric characters.
This allows multiple measurements to be displayed at the same
time and reduces the amount of abbreviations required, simplifying
the operation and reducing confusion. All of the programmed
setpoints are stored in permanent memory to eliminate the need
to reprogram the system after a shutdown or battery replacement.
The OutBack MATE also includes a built in real time clock and
calendar which allows programming of the inverter operation
based on the time of day and even day of the week. This can
be used to allow the system to work with time-of-day power rates
or to limit a generator's run time to a specific time period
of the day or week. The OutBack MATE also includes an opto-isolated
RS232 port with a DB9 jack for connection to the serial port
of a PC computer. OutBack is working with several third party
developers to offer Windows based software programs for datalogging
and graphical display of the system’s operation and performance.
This PC computer software will be available separately and is
expected in September, 2002.